INVESTIGATION ON STONE DUST AND VITRIFIED SCRAP …

2021-2-27 · water improper drying and too much of heating. No work has been reported using stone dust and vitrified scrap together in concrete so far. One such option is the use of stone dust One such option is the use of stone dust a by-product of crushers as replacement of stone dust and ceramic waste as a replacement of coarse aggregate. These

Stone Dust in Concrete: Effect on Compressive Strength

2017-8-24 · Abstract- Stone dust is a waste material obtained from crusher plants. It has potential to be used as partial replacement of natural river sand in concrete. Use of stone dust in concrete not only improve the quality of concrete but also conserve the natural river sand for future generations. In the present investigation, an experimental program was carried out to study the workability and compressive strength of concrete made using stone dust as partial replacement of fine aggregate in the range of 10% - . M25 grade of concrete was designed using Portland pozzolana cement (PPC) for referral concrete. Workability and Compressive strength were determined at different replacement level of fine aggregate viz a viz referral concrete and optimum replacement level was determined based on compressive strength. Results showed that by replacing 60% of fine aggregate with stone dust concrete …

An Experimental Investigation on Stone Dust as Partial ...

2014-10-11 · The test results indicate that stone dust can be effectively used in partial replacement of fine aggregate in concrete. It is found that the compressive and flexural strengths of concrete increase on use of stone dust. The replacement level of the fine aggregate (30, 40, 50, 60 and 70%) by stone dust …

Experimental Investigation on the Concrete as a Partial ...

2015-12-8 · aggregate. The use of stone dust in concrete as partial replacement of fine aggregate will be an alternative material instead of conventional fine aggregate. This will result in conservation of natural resources (fine aggregate) up to some extent, besides helping in environment protection and disposal of stone dust in abundance.

Utilization of Stone Dust as an Effective Alternative for ...

2020-11-6 · Stone dust (SD) is one such alternative material which can be successfully used in construction and used as partial replacement of natural sand. The influence of the SD on fresh and hardened properties of concrete are examined and presented in this paper. In this study, sand is replaced by stone dust in different percentages ranging from 0 to 60%.

Investigation of the mechanical strength of stone dust and ...

2021-1-1 · The results showed that the replacement of stone aggregates with ceramic waste alone tends to reduce the mechanical strength of the concrete. As compared to conventional concrete, compressive and flexural strength of the S0C20 sample (i.e. 0% stone dust and 20% ceramic) is slightly reduced.

Utilization of Stone Dust as Fine Aggregate Replacement in ...

Utilization of Stone Dust as Fine Aggregate Replacement in Concrete

(PDF) Stone Dust as Fine Aggregate Replacement in Concrete ...

with stone dust. The stu dy shows that compressive strength of concrete made using stone dust as fine aggregate. replacement having greater value in comparison of conventional concrete. Brajesh ...

(PDF) STUDIES ON UNPROCESSED STONE DUST AS FINE …

They have concluded that incorporation of upto 10% limestone dust as a partial replacement for FA in concrete with w/c = 0.70 and 5% limestone dust in concrete with w/c = 0.53 does not significantly affect the properties of fresh and hardened concrete. However, there is considerable loss in slump, irrespective of w/c ratios, if lime stone dust ...

STUDY ON PROPERTIES OF CONCRETE (M40) USING …

2018-5-12 · STUDY ON PROPERTIES OF CONCRETE (M40) USING STONE DUST AND DEMOLISHED CONCRETE WASTE AS PARTIAL REPLACEMENT OF FINE AND COARSE AGGREGATE: A REVIEW Utpal Singh1, Mohd. Afaque Khan2, Neeti Mishra 3,Shubhranshu Jaiswal4 1PG Student, Department. of Civil Engineering, Babu Banarsi Das University, U.P., INDIA

Replacement Of Coarse Aggregate In Concrete | Alternative ...

2  · As concrete demand and conumption is increased rapidly demand of natural aggregate also rised. Similarly, the production of natural coarse aggregate is not sufficent ro satisfied these increased demand.Therefore, as a solution and to save enviroment the replacement of coarse aggregate in concrete is become essenetial.. Theare various alternative materials for coarse aggregate such as …

Strength Characteristics of Concrete with Stone Dust as ...

2020-5-16 · course aggregate .the quality of stone dust depends upon the crushers running time and quality of rock .lesser the percentage of finer particle more is suitability of stone dust for replacement of sand. Rock dust is a frictional material as sand and it has a potential as fine aggregate in concrete

Experimental Study on Concrete by Partial Replacement …

2018-2-18 · Stone Dust Stone dust produced from stone crushing zones appears as a problem for effective disposal. Hence in this work stone dust is used in the concrete as partial replacement of the sand. The main purpose of this work is to waste minimization. The study focuses to determine the relative performance of concrete by using stone dust.

PARTIAL REPLACEMENT OF CEMENT AND FINE …

2018-4-8 · Stone dust, is an inert material and may be used in concrete making as partial replacement of cement and fine aggregate. Natural sand is basically and mostly used fine aggregate all over India, but as compare to some advanced countries, the volume of concrete

Influence of stone dust as fine aggregate replacement on ...

2018-6-7 · investigate the influence replacement of natural sand by stone dust (5%, 10%, 15%, 20%, 25% and 30%) in workability, air content, compressive strength, impact strength, permeability and retraction of concrete samples. It was found that the 10% of replacement increased the compressive strength of concrete; however, 5% of stone dust was

Suitability of Stone Dust in Concrete

2018-6-13 · suitability of stone dust in concrete as partial replacement of conventional fine aggregate (natural sand). To accomplish this specimen were cast for different replacement level. Results show that at all the replacement level compressive strength is more than that of referral concrete.

(PDF) Stone Dust in Concrete: Effect on Compressive Strength

Abstract and Figures Stone dust is a waste material obtained from crusher plants. It has potential to be used as partial replacement of natural river sand in concrete. Use of stone dust in concrete...

(PDF) Stone Dust as Partial Replacement of Fine Aggregate ...

Experimental programme was conducted using 30%, 40%, 50%, 60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M25 grade with 0.46 water cement …

Use of Quarry Dust to Replace Sand in Concrete – An ...

2021-6-4 · Two grades of concrete M20 and M25 having nominal mix proportion of 1:1.5:3 and 1:1:2 respectively were used by weight and w/c ratio was fixed according to the slump requirement of 60mm. For this concrete mix, quarry dust was added for replacement of sand from 0% to in step of 10%.

Influence of stone dust as fine aggregate replacement on ...

2017-12-29 · The use of stone dust in concrete provides environmental benefits by reducing the impacts produced by the extraction of natural sand. The use of this material can also offer economic advantages, since the product is less costly than natural sand. In this way, the present work evaluated the compressive strength of concretes made with stone dust in different replacement levels (30% and …

Use of Stone Dust as Replacement of Fine Aggregate in ...

2018-6-22 · others for hardened concrete samples. The concrete samples (50% replacement with stone dust) were also studied for durabil-ity by immersing the concrete cube in 5% solution of Magnesium Sulfate, 5% solution of Sodium Chloride and 2N Hydro-chloric Acid solution for 28 and 91 days.

Behaviour of Concrete by Partial Replacement of Fine ...

2018-2-13 · Stone dust. The Glass Powder is used as 20% replace by weight of cement and Stone Dust as the partial replacement of Fine Aggregate from 0%, 10%, 20%, 30% and 40%. The grade of the concrete here is M-25 grade. It has been used as a replacement of …

An Experimental Study on Partial Replacement of Sand …

2016-3-3 · Illangoan.R1 [2000] has done a study on replacement of sand by quarry dust in concrete. The compressive strength of concrete with quarry dust has 40%more strength than that of the concrete with sand. M. Shukla and A K Sachan2 (2000) studied environmental hazardous stone dust utilization in building construction.

Utilization of Stone Dust as Fine Aggregate Replacement …

2015-4-30 · Stone dust is to be used as partial or full replacement of natural fine aggregate in concrete. The use of stone dust in concrete is beneficial in different manner such as environmental aspects, non-availability of good quality of fine aggregate, strength criteria etc.

What are the Materials for Replacement of Sand in Concrete ...

2021-8-23 · Crusher dust (quarry waste) is by product of stone crushers while producing coarse aggregate. Instead of disposing them in landfills, it can be best utilized as partial replacement to sand. In crusher dust, the particles (% finer than 150 microns) are generally high, a major concern limiting its percentage replacement …

Effect of Partial Replacement of Cement by Fly Ash and ...

2015-12-1 · Effect of Partial Replacement of Cement by Fly Ash and Fine Aggregate by Marble Dust, Stone Dust on Concrete Properties Author: ANAND Keywords: Keywords: Ordinary Portland Cement(43 Grade), Industrial Waste Fly Ash, Marble Dust & Stone Dust Created Date: 12/1/2015 4:51:31 PM

Effect of stone dust on strength of concrete

2021-7-4 · stone dust and superplasticizer to reduce w/c ratio. Cubes and under reinforced beams were casted by replacing fine aggregate 25%, 50%, 75% and by stone dust and test have conducted for their relevant parameters. They concluded from the experiments that replacement of sand by stone dust

Replacement of stone Dust and Ceramic scrap as …

2020-10-31 · Compressive strength of concrete made using 05 % ceramic waste aggregate and 05 % stone dust as replacement of coarse aggregate and fine aggregate respectively, is about 20% more than that of referral concrete at 28 days. However, compressive strength at 05% recycled aggregate and 05% stone dust is marginally than that of conventional concrete.